recrystallization temperature

Recrystallization occurs during tensile deformation at a high temperature and T1 phase dissolved in matrix. ( 3) The fracture of the alloy appears obvious hierarchical characteristics, with dimple, when tension specimen at Room temperature.

高温变形时出现动态再结晶，T1相消失。（3）2198（T851）合金室温拉伸断口有明显的分层断裂的特征，并带有韧窝。

Recrystallization Temperature of Cold Deformed Steel and Its Influencing Factors

冷变形钢的再结晶温度及其影响因素

Trace lithium can improve recrystallization temperature of pure copper.

在工业纯铜中加入微量锂能提高其再结晶温度.

The coarse crystalline LC4 alloy exhibit some superplasticity under lower temperature and higher strain rate, because it can create effective recrystallization refinement.

粗晶LC4合金在较低温度和较高应变速率条件下，因能产生有效的再结晶细化，而呈现出一定的超塑性。

Research Progress on Raising Recrystallization Temperature of Doped Molybdenum Wire

掺杂提高钼丝再结晶温度的研究进展

The elevation of the recrystallization temperature could mainly attributed to the Sc.6. The recrystallization mechanism of Al-Mg and Al-Mg-Sc alloy include nucleation of grain boundary remotion and combination-grow up of subgrain.

稳定化退火过程中，铝镁及铝镁钪合金的再结晶机制有晶界弓出形核及亚晶合并长大。

The recrystallization temperature and the strenth of molybdenum thermionic cathode wires are increased greatly by addition of about 4wt% content of rare earth oxides.

4wt%左右稀土氧化物的加入，能显著提高钼热阴极丝材的再结晶温度和室温抗拉强度。

Static recrystallization all occurs in the range of 3~ 200 s interval time when double-pass compression test at constant temperature is conducted.

恒温双道次压缩时，在3￣200s的间隔时间内均发生了静态再结晶。

Deformation determines recrystallization score when it has same deformation temperature and heat preservation time. Deformation in the materials produced more distortion and can increase the recrystallization driving.

变形温度和保温时间相同时，变形量的大小决定了再结晶分数的大小，变形量的增大使材料内部产生了更多的畸变能，使再结晶的驱动力增大。

The recrystallization temperature and time are the main factors.

再结晶温度、时间是立方织构形成的主要影响因素。

Relation of rolling process to metallurgical structure and recrystallization temperature of tym molybdenum alloy

TYM钼合金轧制工艺与组织结构及再结晶温度的关系

In situ recrystallization during elevated temperature deformation in fe_3al based alloy

Fe3Al基合金高温变形过程中原位再结晶现象